ICM Controls ICM2918 Universal Intermittent Pilot Gas Ignition Control Module

The ICM2918 Universal Intermittent Pilot Gas Ignition Control Module is a field service replacement for many popular flame rectification type of intermittent pilot ignition (IPI) modules. Provides electronic control for most intermittent pilot ignition systems used on gas-fired furnaces, boilers, and other heating appliances.

Replaces ICM290A, Honeywell S8610U & over 280 other models from Camstat, Fenwal, UTEC/HSC, Johnson Controls, Robertshaw and White-Rodgers.

Provides ignition sequence, flame monitoring and safety shutoff for single/dual rod intermittent pilot control applications
For gas fired furnaces, boilers and other heating applications
Switch selectable pre-purge and ignition trials with permanent lock
Works with or without vent damper connected
Works with both Natural Gas and LP Gas systems

Sell Sheet

Installation Guide

SPECIFICATIONS

Control voltage: 18-30 VAC @ 50/60 Hz
Trial for ignition: 15 or 90 seconds (switch settable)
Operating temperature: -40°F (-40°C) to 165°F (74°C)
Relative humidity: 5% – 95% (non-condensing) at +55°C
Pre-purge time: 0 sec or 30 sec (switch settable)
Green status LED: System status and error codes
Yellow flame LED: Flame presence and flame strength

Cost effective replacement to the Honeywell S8610U3009 Universal Intermittent Pilot Module and over 280 other Pilot Controls… See all replacements below: